PVI Industries SU-3 Guide de dépannage

PV500-17 07/13 Section 17 1INSTALLATION & MAINTENANCE MANUAL FOR MAXIM INTEGRATED WATER HEATING SYSTEM IMPORTANT: READ AND FOLLOW THE INFORMA

PV500-17 07/13 Section 17 10MAXIM AXIAL FLOW GAS BURNER START-UP (continued) PRESSURE PLATE Set up and Tolerances Figure 17-3 13. Connect a test

PV500-17 07/13 Section 17 11MAXIM AXIAL FLOW GAS BURNER START-UP (continued) This section pertains to MEC120 control only. When the blower motor

PV500-17 07/13 Section 17 12MAXIM AXIAL FLOW GAS BURNER START-UP (continued) 18. Check flue gases with a flue analyzer to make final settings of th

PV500-17 07/13 Section 17 13MAXIM TROUBLESHOOTING SUGGESTIONS AXIAL FLOW GAS BURNER 1. BURNER FAILS TO START Defective On/Off switch. Replace swit

PV500-17 07/13 Section 17 14MAXIM TROUBLESHOOTING SUGGESTIONS AXIAL FLOW GAS BURNER (continued) C. Defective automatic main or auxiliary gas shut

PV500-17 07/13 Section 17 2MAXIM INTEGRATED WATER HEATING SYSTEM TYPICAL CONSTRUCTION - MX MODEL FIGURE 17-1 1. VENT STACK * 8. HANDHOLE CLE

PV500-17 07/13 Section 17 3MAXIM PRODUCT SAFETY INFORMATION REFRACTORY CERAMIC FIBER PRODUCT WITH CRYSTALLINE SILICA WARNING: This product conta

PV500-17 12-2004 Section 17 4 MAXIM START-UP PROCEDURES WARNING! This water heater is equipped with an adjustable thermostat to control water tem

PV500-17 07/13 Section 17 5 MAXIM START-UP PROCEDURES (con't) CAUTION! Conduct the following gas train leakage test before start-up, at annual

PV500-17 07/13 Section 17 6MAXIM MAINTENANCE AND SAFETY INSPECTIONS (con't) 4. The tank will have a handhole for inspection and cleaning. (Se

PV500-17 07/13 Section 17 7MAXIM MAINTENANCE AND SAFETY INSPECTIONS (con’t) Instructions for Taking Water Heater Out of Service Extended shutdown

PV500-17 07/13 Section 17 8MAXIM AXIAL FLOW GAS BURNER CARBON MONOXIDE WARNING! CAUTION: IMPROPER COMBUSTION MAY CAUSE SERIOUS INJURY. PVI recomm

PV500-17 07/13 Section 17 9 MAXIM AXIAL FLOW GAS BURNER START-UP (Refer to Figure 17-2, page 8 to identify burner parts) 1. Remove the enclosure pa